Choose where the text sits
Turn a slide's text on or off, pick where the words sit against the media, and time them on a video.
1 min read
Everything about the words on a slide is in the Text section of the inspector. This section used to be called Design.
Turn text on or off
The switch in the section header turns the slide's text on or off. Off gives a media-only slide and hides the text options. Your words are kept and come back when you turn it on again.
Layout
Once a slide has a scene, Layout sets where the words sit relative to the media:
- Overlay left
- Overlay centre
- Text left
- Text right
- Text below
Each is shown as a thumbnail and applies to the slide straight away. Style holds the look of the text.
Timing (video slides only)
On a video slide, Text gains a third tab, Timing, which sets when the text shows:
- While paused: the video is paused with the text over the top.
- While playing: the text stays on screen as the video plays.
- At the end: the video plays through and the text appears when it finishes.
The slide shows your choice, with a marker on the scrubber where the text appears. With Text off there's no timing to set, so the tab goes away.